TM 5-4310-451-14
5-63. BLOWER ASSEMBLY REPLACEMENT (Cont).
8.
Torque two screws (29) to 40-45 lb.-ft. (54-61 Nom).
9.
Torque four screws (28) evenly to 30-35 lb.-ft. (41-47 Nom).
10.
Repeat step 8.
NOTE
Drive shaft must move freely. Perform step 11 If it does not.
11.
Check movement of drive shaft (15). If drive shaft does not move freely, loosen screws (28 and 29) and repeat
steps 8 through 10.
12.
Push In on drive shaft (15) and install retaining ring (14).
13.
Install hoses (22), one on each side of governor (18), and tighten two clamps (21) over hoses.
14.
Install two fuel control rods (23), one through each side of governor (18), and install fuel rod connecting pin (19)
and connecting pin (20).
15.
Install other end of fuel control rods (23) to control tube devises (25) with pins (26) and new cotter pins (27).
TA705085
5-214