TM 5-4310-452-14
4-25. ENGINE THROTTLE CONTROL MAINTENANCE (Con't).
4.
Remove rod end (11), jamnut (23), nut (22), and retaining plate (21) from cylinder (4).
5.
Remove sleeve (20) from cylinder (4).
c.
ASSEMBLY
1.
Install sleeve (20) in cylinder (4).
2.
Install retaining plate (21) on cylinder (4) with nut (22). Hand tighten nut.
3.
Install jamnut (23) and rod end (11) on cylinder (4) rod.
4.
Install collar (18) on shaft (17) with screw (19). About 1/4 in. (6.35 mm) of shaft should be visible.
5.
Install spring (16), spring (15), seat (14), on shaft (17) with 2 nuts (13).
6.
Install spring rod ball joint (7) on threaded end of shaft (17).
d.
INSTALLATION
1.
Position air cylinder assembly (4) in bracket (2).
2.
Install screw (1) and nut (3) in air cylinder assembly (4) and bracket (2).
3.
Install bracket (2) with 2 screws (12).
4.
Line up rod end (11) with lower hole in throttle arm (8). Install screw (10) and nut (9) in rod end and throttle arm.
5.
Install spring rod ball joint (7) In upper hole of throttle arm (8) and install nut (5) and new lockwasher (6).
6.
Install air lines and fittings (see paragraph 4-98).
TA505445
4-47
