TM 5-4310-452-14
4-27. FUEL/WATER SEPARATOR ELEMENT MAINTENANCE (Con't).
3.
Install new preformed packing (18) on vent plug (11) and install in head (15).
4.
Install new preformed packing (9) on plug (10) and install in sight bowl (6).
5.
Install drain assembly knob (7) on sight bowl (6).
6.
Install sight bowl (6) with new preformed packing (5) on new separator element (4).
7.
Install head (15) on baffle with 2 screws (1) and nuts (3),
8.
Apply a light film of lubricating oil on separator element (4) gasket and install on head (15).
9.
Install drain hose (8) on drain assembly knob (7). Close drain assembly knob.
d.
INSTALLATION
1.
Install fuel lines and fittings (see paragraph 4-24).
2.
Loosen probe (12). Pump probe until pressure is felt and sight bowl is full of fuel. Tighten probe.
FOLLOW-ON TASKS:
• Bleed fuel system (see paragraph 4-21).
•·Start unit and check for leaks (see paragraph 2-12).
•·Close left door assembly.
TA505448
4-51
