TM 5-4310-452-14
4-33. BLOWER ASSEMBLY FAN BELT REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Engine off.
• Twenty-two self-locking nuts
• Left and right door assemblies opened.
• Battery cables disconnected (see paragraph
Tools/Test Equipment:
4-57).
• General mechanic's tool kit
•·Alternator belt removed (see paragraph 4-37).
a.
REMOVAL
1.
Remove screw (6), washer (5), 2 capscrews (4), and self-locking nuts (2) from air intake connector (3).
Discard self-locking nuts.
2.
Remove air intake connector (3) from blower assembly (1).
3.
Lift idler pulley (8) and remove fan belt (7).
b.
INSTALLATION
1.
Lift idler pulley (8) and install fan belt (7).
2.
Position air intake connector (3) in place on blower assembly (1).
3.
Install screw (6), washer (5), capscrews (4), and 2 new self-locking nuts (2).
TA505456
4-62
