(8) Low pressure lubricant pump,
1-5. Identification and Tabulated Data
Manufacturer
Stewart Warner
a. Identification. The lubricating and servicing
Model
G330768
unit has five major data and instruction plates. The
Ratio
12 to 1
information contained on these plates is listed below.
(1) Lubricutor Corp of Engineers data plate.
(9) Type of lubricants required.
Located on the left side of the unit enclosure. It gives
High pressure pump
General purpose grease
Low pressure pump
Engine and gear oil
the description, serial number, manufacturer, model
(10)Batteries.
and dimensions.
Voltage
12
(2) Trailer CorpS of Engineers plate. Located on
Negative ground
Type
the bulkhead at the front of the trailer. It gives the
Number used
2
manufacturer, model, dimensions and capacity.
(11) Alcohol dispenser.
(3) Engine data plate. Located on the top of the
Manufacturer
Norgren, C. A. Co.
engine block. It specifies the make, model, type,
Model
10-002-124
number of cylinders and piston displacement.
(4) Compressor data plate. Located on the com-
(12) Trailer.
pressor body. It gives the manufacturer, model and
Manufacturer
Henry Spen and CO.
serial number.
Model
906936-1
Type
Military Standard
(5) Transportation data plate. Located on the
900 x 20
Tire size
enclosure next to the corps of engineers plate. It gives
Tire pressure:
the center of gravity, axle load and pintle load in
Normal
50 lbs.
pounds.
Sandy or rough terrain
40 lbs.
Contract number
DAAKO1-67-C-1259
b. Tabulated Data.
Pay load
5,000 Ibs.
(1 ) End item.
Cube
458cu. in.
Henry Spen and Co.
Manufacturer
90176.5-1
Model
(13) Capacities.
(2) Engine.
Hydraulic brake system
5/16 qt. (quart)
NOTE
Engine crankcase
21/8 qt.
Military Standard Engine Refer to TM 5-2805-203-l.t
Engine oil filter
1 pt. (pint
Compressor crankcase
2 qt.
for engine and accessory tabulated data, except for
Fuel tank
10 gal. (gallons)
starter and generator listed below.
Alcohol dispenser
qt.
(3) Generator.
Lubricant storage containers:
Electric Autolite Corp.
Manufacturer
Lubricating grease
175 lb. (pounds)
GKP 4001
Model
Lubricating gear oil
27 gal.
Volts
24
27 gal.
(4) Starting motor.
(14) Dimensions.
Delco Remy
Manufacturer
Model
1113516
Length (a) Trailer.
172 in. (inches)
Volts
24
96 in.
Width
(5) Air compressor.
Height
48 in.
Weight
2,730 Ibs.
Saylor-Beall Manufacturing Co.
Manufacturer
705
Model
(b) Lubicator and trailer.
2 cylinder, 2 stage, vertical
Type
Height
76 in.
Type drive
Belt
Length
173 3/8 in.
23.0 cfm
Displacement
96 in.
Width
150-175 psi
Operating pressure
Shipping weight
(5,500 lbs.
(6) Transfer pump.
Shipping cube
758 cu. ft. (cubic feet)
Center of gravity
25 in. above-ground level and
Stewart-Warner
Manufacturer
114 in. from lunette end
Model
330783
75-150 psi
Operating pressure
(7) High pressure lubricant pump.
Stewart Warner
Manufacturer
(15 ) Trailer wiring Diagram. Refer to figure 1-5
G330769
Model
for the trailer schematic wiring diagram.
40 to 1
Ratio
1-7
