TM 9-4310-394-13WARNINGHIGH VOLTAGEis used in operation of this equipment.DEATH ON CONTACTmay result if personnel fail to observe safety precautions.Never work on electrical equipment unless there is another person nearby who is familiar with operationand hazards of equipment and who is competent in administering first aid. When technician is aided byoperators, he must warn them about dangerous areas.Whenever possible, input power supply to equipment must be shut off before beginning work. Takeparticular care to ground every capacitor likely to hold a dangerous charge. When working inside, afterpower has been turned off, always ground every part before touching it. Be careful not to contact highvoltage connections when installing or operating this equipment.Whenever nature of operation permits, keep one hand away from equipment to reduce hazard to currentflowing through vital organs of body. Do Not operate equipment without all guards, louvers, and covers inplace and tightly secured.(1) Connect the positive connector of the power source to the top terminal of the motor starter solenoid.(2) Connect the negative connector of the power source to the axle of the unit. Rotate the connector a little toinsure that the connector is in good contact with the metal of the chassis.d. ConnectionofAirHoseToUnit. (Refer to Figure 2-2). Before the air compressor is fully operational, the airhose must be installed onto the air receiver tank. To install the air hose, attach the air hose (7) into the air receiver tank(8).Figure 2-2. Refueling Air Compressor Unit.2-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
