TM 9-4310-394-13(3)Remove any preservation barrier by tearing around the bottom of the cabinet.(4)Remove the technical publications envelope and accessory sack that are taped to the unit and put them ina safe place.(5)Remove and retain the pallet and crate if re-use is anticipated.(6)Put the unit onto floor in the desired position.c. CheckingUnpackedEquipment. To check the unpacked air compressor unit, perform the followingsteps.(1)Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, reportdamage on DD Form 6, Packaging Improvement Report.(2)Check the equipment against the packing slip to see if the shipment is complete. Report all discrepanciesin accordance with the instructions as defined within DA PAM 738-750. See that all components of enditem and basic issue items are with the equipment.(3)Check to see whether the equipment has been modified.4-6. INSTALLATION INSTRUCTIONS. Because the air compressor unit is a self contained operating system, itrequires no installation.4-7. PRELIMINARY SERVICING AND ADJUSTING OF EQUIPMENT. The air compressor unit must be filled with fueland the V-belt must be adjusted before the unit can be put into operation. To fill with fuel, refer to paragraph 2-7. Toadjust the V-belt, perform the following procedures.(1)(Refer to Figure 4-1). Remove four screws (1), four lock washers (3), and four flat washers (2).(2)Remove two screws (4), two lock washers (5), and two flat washers (6).(3)Remove nut (7), screw (8), bracket (9), and bracket (10).(4)Remove top of belt guard assembly (11) from unit.(5)(Refer to Figure 4-2). Check that the deflection of the V-belt (3) is 1/4 in. as indicated in the figure. Ifdeflection is incorrect, change deflection by adjusting the engine take-up screw by performing the following procedures.(a)Loosen four nuts (1) which hold engine (2) onto chassis.(b)Adjust take-up screw (4) until 1/4 in. deflection is measured on the V-belt (3).(c)Tighten four nuts (1) which hold the engine (2) to the chassis.(6)(Refer to Figure 4-1). Place top of belt guard assembly (11) onto unit and install two flat washers (6), twolock washers (5), and two screws (4).(7)Install bracket (10), bracket (9), screw (8), and nut (7).(8)Install four flat washers (2), four lock washers (3), and four screw (1).4-3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
