TM9-4310-396-13
MAINTENANCE OF VEHICULAR STOP LIGHT AND INDICATING REFLECTOR
4-28.
REPLACE VEHICULAR STOP LIGHT AND INDICATING REFLECTOR.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools
Equipment Conditions :
General Mechanics Tool Kit
None
Materials/Parts
Rag, Wiping (Appendix E, item 3)
Vehicular Stop Light (P/N 11-102)
Solvent, Dry Cleaning (Appendix E, item 2)
Indicating Reflector (P/N 11-511)
a.
Removal.
(1)
Remove plug (1, Figure 4-16) from vehicular stop light (2).
(2)
Apply pressure from inside of complete top hood assembly to remove vehicular stop light (2).
(3)
Pry off indicating reflector (3).
b.
Installation.
(1)
Install vehicular stop light (2) by pressing in from outside of complete top hood assembly.
(2)
Connect plug (1) to vehicular stop light (2).
WARNING
Dry cleaning solvent used to clean parts is potentially dangerous to personnel and
property. Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes. Wear
goggles and rubber gloves to protect eyes and skin. Wash exposed skin thoroughly. Do
not smoke or use near open flame or excessive heat. Failure to observe this warning
may result in severe personal injury or death.
(3)
Clean all residual adhesive from metal surface where reflector is located.
(4)
Wipe dry.
(5)
Peel backing from indicating reflector (3) and apply to trailer.
4-51