TM 9-4310-397-14
4-55. COMPRESSOR OIL FILTER REPLACEMENT. - Continued
(2)
Remove two hex head bolts (3), lock washers (4), bypass connector (5), elbows (6) and (7), and gasket
(8). Discard gasket and lock washer.
(3)
Remove thermal bypass (9), connector (10), and preformed packing (11). Discard preformed packing.
b.
Installation.
(1)
Wrap antiseize tape (item 1, section II, appendix E) on threaded ends of adapter (10), elbows (6), and
(7).
(2)
Assemble elbows (6) and (7), thermal bypass (9), new preformed packing (11) (item 21, appendix H),
and adapter (10).
(3)
install new gasket (8) (item 19, appendix H), bypass connector (5), elbow (6), and two hex head bolts (3)
and lock washers (4) (item 16, appendix H).
(4)
Install adapter (2) and filter (1).
(5)
Check condition of decal (12) and install a new one if old decal is not readable, or if a new filter was
installed without a decal.
(6)
Connect oil lines per paragraph 4-50.
(7)
Refill compressor with oil per paragraph 4-6, d, (2).
(8)
Connect battery cables to batteries per paragraph 4-49.
4-138
