TM 9-4310-397-14
(a)
Remove air hose lines (2), adapters (3), and elbow (4).
(b)
Remove two nuts (5), speed control rod (6), and spring (7).
(c)
Loosen setscrew (Figure 4-60, 1) and remove knob (2).
Figure 4-60. Air Compressor Inlet
(d)
Remove two hex washer head bolts (3), guide plate (4), and one grommet (5).
(e)
Remove five cap screws (6), one cap screw (7), six lock washers (8), and spring bracket (9). Discard lock
washers.
(f)
Remove slotted hex nut (10), cover (11), and rod (12) as an assembly.
(g)
Remove unloader pin (13).
(h)
Remove diaphragm (14).
(i)
Remove lock nut (15), intake control piston (16), spring (17), air intake cylinder (18), and intake control
stem (19) as an assembly.
(j)
Remove gasket (20), spring (21) and intake control valve (22).
(k)
Remove two hex head screws (23), lock washers (24), inlet housing (25), and gasket (26). Discard gasket
and lock washers.
4-149