TM 9-4310-397-14
Figure 6-59. Oil By-pass Valve
(f)
Apply a light coating of Permatex No. 3 (or equivalent) to cylinder block side of new gasket.
(g)
Install new gasket (item 59, appendix H) and front plate. Place new external-tooth washers (item 77,
appendix H) on screws and torque screws 25 ft-lb. (35 Nm).
(h)
Cut off protruding edge of gasket only after timing gear cover has been tightened.
Figure 6-60. Front Plate Installation
(2)
Install and time camshaft.
(a)
Make sure engine is at TDC, (No. 1 piston on compression stroke) with timing pin engaged in flywheel.
(b)
Install fuel injection pump hex nut (Figure 6-15, 4), washer (5), and pump drive gear..
(c)
Torque injection pump-to-front plate hex nuts 18 ft-lb. (25 Nm). Torque injection pump drive gear hex
nut (4) to 44 ft-lb (60 Nm).
(d)
Put clean engine oil on camshaft bearing journals.
6-51
