TM 9-4310-397-14
Figure 6-66. Install Oil Deflector
(c)
Apply a light coating of non-hardening sealant to cylinder block side of a new gasket. Position gasket
(item 60, appendix H) on front plate.
CAUTION
Do not invert crankshaft front oil seal lip.
(d)
Install gear cover, alternator mounting bracket, gear cover cap screws, and washers. Torque to 35 ft-lb
(50 Nm).
(6)
If a new front plate-to-engine block gasket was installed, trim off protruding portion of both gaskets and
apply sealant.
(7)
Install the oil pressure regulating valve assembly and torque plug (Figure 6-37, 1) to 70 ft lbs (95 Nm).
(8)
Install oil pan per paragraph 6-7.
(9)
Install pulley on crankshaft per paragraph 6-10.
(10)
Install fuel transfer pump per paragraph 4-68.
(11)
Remove cam follower lifting tools (if used for camshaft removal).
(12)
Install push rods and rocker arm assembly per paragraph 6-6.
(13)
Install alternator, fan belt, and fan per paragraph 4-65.
(14)
Install engine per paragraph 4-72.
(15)
Fill engine crankcase with clean oil having correct viscosity and grade specifications per paragraph
4-6, c, (2).
(16) Adjust valve clearance per paragraph 6-6.
(17) Install rocker arm cover per paragraph 5-6.
6-55