TM 5-4220-227-14
4-43. Communicator Assembly
This task covers:
Replace
INITIAL SETUP:
Tools
Personnel Required
General Mechanic's Tool Kit
Two
(NSN 5180-00-177-7033)
Materials/Parts
Communicator Assembly
Replace. (figure 4-30)
(1)
Unlatch two latches (1), open hood assembly door (2), and install two supports (3) and pins (4).
(2)
Disconnect communicator assembly electrical plug (5) from the power strip (6).
(3)
Disconnect hand held MIC (7) from communicator assembly (8).
(4)
Disconnect hand held MIC cables (9) from communicator assembly (8).
(5)
Remove four screws (10) and pull communicator assembly (8) out far enough to provide access the back
of the assembly to disconnect electrical cable.
(6)
Disconnect electrical cable (11) from J-6 connector.
(7)
Remove communicator assembly (8) from control panel (12).
(8)
Connect electrical cable (11) to J-6 connector.
(9)
Install communicator assembly (8) into control panel (12) and secure with four screws (10).
(10)
Connect hand held MIC cables (9) to communicator assembly (8).
(11)
Connect hand held MIC to communicator assembly (8).
(12)
Connect communicator assembly electrical plug (5) to power strip (6).
(13)
Remove two pins (4), supports (3), close hood assembly door (2), and secure with two latches (1).
4-70