TM 5-4220-233-14
(5) While supporting tubes connected to filter (1) install and tighten cap (2).
b.
Removal.
(1) Disconnect tube assembly (4) from Inlet port on filter (1) and manifold valve
(2) Remove tube assembly (4) and bag.
(3) Disconnect tube assembly (5) from outlet port on filter (1).
(4) Note direction of flow arrow on filter (1) then pull filter out and bag.
c.
Cleaning of Filter. Refer to Section VII to clean replacement filter as required.
d.
Installation.
(1) Connect tube assembly (5) to outlet port of filter (1) with flow arrow oriented as previously noted.
(2) Connect tube assembly (4) to inlet port of filter(1) and manifold valve.
(3) Perform a leak check on filter connections as prescribed in paragraph 4-20.
4-57
