TM 5-4220-233-14
4-42. HUB AND DRUM ASSEMBLY.
This task covers:
a.
Removal
b.
Cleaning
c.
Installation
INITIAL SETUP :
Tools
Materials/Parts Appendix D
Mallet, rubber
Wiping Rag ( item 13 )
Pliers, Slip Joint
Cleaning Solvent (item 15 )
Pliers, Needle Nose
Gear Oil (item 12)
Puller Kit, Mechanical
Container (item 7)
Screwdriver, Flat Tip
Seal
Wrench, Hex 1/8"
Gasket
Gasket
Cotter Pin
Equipment Conditions
Wheel & Tire Assembly Removed
(Paragraph 3-5)
WARNING
Prior to performing this task the Servicing Unit should be positioned on a
hard flat surface and the swivel jacks should be lowered to provide a firm
stable foundation. Failure to follow this warning may result In serious Injury
or equipment damage.
NOTE
This procedure describes the removal and replacement of the hub and drum
assembly, wheel bearings, and the seal for the Servicing Unit.
4-62