TM 5-4220-233-14
4-44. BRAKE SHOES.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP :
Tools
Materials/Parts Appendix D
Mallet, rubber
Wiping Rag (item 13)
Pliers, Slip Joint
Cleaning Solvent (item 15)
Pliers, Needle Nose
Silicone Grease (item 11)
Puller Kit, Mechanical
Container (item 7)
Screwdriver, Flat Tip
Hold down Pins
Wrench, Hex 1/8"
Hold down Springs
Brake Shoes
Equipment Conditions
Wheel & Tire Assembly Removed
(Paragraph 3-5)
Hub and Drum Assembly Removed
(Paragraph 4-42)
WARNING
Brake shoe linings contain asbestos fibers which present a serious health
hazard if inhaled. Use asbestos dust control procedures approved by local
medical authority when servicing the brake assembly. Never use
compressed air to clean dust from brake system components, or wipe, brush
or sweep dry dust. Failure to follow proper precautions may result In
exposure to dangerous concentrations of airborne asbestos fibers.
a.
Removal.
(1) Place an empty container below the brake assembly to capture the fluid that will drain when brake line
is disconnected from brake cylinder
4-67
