based on average use of the equipment under normal
(see Figure 5-13). Thoroughly clean the strainer and the
climatic conditions and should be reduced accordingly
other internal parts of the assembly with dry-cleaning
when the unit is operated continuously for long periods
solvent (Federal Specification P-S-661) and dry with
of time or under adverse conditions.
clean, lint-free cloths. Reassemble the parts and adjust
the assembly in accordance with the instructions In
paragraph 4.14. P.5
3.4 LUBRICATION
3.2.6 GASOLINE ENGINE. Clean the engine fuel filter,
3.4.1 After each 50 hours of accrued compressor
carburetor air cleaner and other component parts in
operating time, drain the lubricating oil from the oil
accordance with the instructions contained in Part II of
reservoir and refill with fresh oil in accordance with the
this manual.
lubrication order (figure 3-1) and the following
procedures:
3.3 PERIODIC INSPECTION
a. Remove breather cover and filter assembly (see
3.3.1 Inspect the compressor package assembly in
accordance with Table 2. The Intervals specified are
TABLE 2. PERIODIC INSPECTION
20
