TM 5-4310-241-35P
INTRODUCTION
Explanation
1. Scope
M
Applied to repair parts which are not procured
This manual lists repair parts required for the
or stocked but are to be manufactured at indi-
performance of direct support, general support,
cated maintenance categories.
A
Applied to assemblies which are not procured
and depot maintenance of the air compressor.
or stocked as such but made up of two or
more units, each of which carry individual
2. General
stock numbers and descriptions and are pro-
cured and stocked and can be assembled by
a. The repair parts list is arranged as follows:
units at indicated maintenance categories.
(1) Individual parts and major assemblies
Applied to parts and assemblies which are not
X
are listed alphabetically by item name within the
procured or stocked, the mortality of which is
numbered functional groups.
normally below that of the applicable end
item, and the failure of which should result
(2) Assembly components and subassemblies
in retirement of the end item from the sup-
are indented and listed alphabetically by item
ply System.
name under major assemblies,
X1
Applied to repair parts which are not procured
b. This Repair Parts and Special Tools List is
or stocked, the requirement for which will be
divided into the following sections:
supplied by use of the next higher assembly
or components.
(1) Repair Parts-Section II. A list of re-
X2
Applied to repair parts which are not stocked.
p a i r parts authorized for the performance of
The indicated maintenance category requiring
maintenance at the direct support, general sup-
such repair parts will attempt to obtain them
port, and depot level.
through cannibalization; if not obtainable
(2) Special Tools, Test and Support Equip-
through cannibalization, such repair parts
will be requisitioned with supporting justifi-
ment-section III. A list of special tools, test and
cation through normal supply channels.
support equipment authorized for the perform-
C
Applied to repair parts authorized for local
ance of maintenance at the direct support, gen-
procurements. If not obtainable from local
eral support, and depot level. Not Applicable.
procurement, such repair parts will be requi-
sitioned through normal supply channels with
(3) Federal Stock Number and Reference
a supporting statement of nonavailability
N u m b e r Index-Section IV. A list of Federal
from local procurement
stock numbers followed by reference numbers in
G
Applied to major assemblies that are procured
ascending alpha-numeric sequence cross-refer-
with PEMA (Procurement Equipment Missile
enced to index number.
Army) funds for initial issue only to be used
as exchange assemblies at DSU and GSU
maintenance level. These assemblies will not
be stocked above DSU and GSU level or re-
The following provides an explanation of col-
turned to depot supply level.
Note. Source code is not shown on com-
umns in the tabular lists in Sections II and III:
mon hardware items known to be readily
a. Source, Maintenance, and Recoverability
available in Army supply channels and
Codes (SMR), Column (1).
through local procureunent.
(1) Source code, indicates the selection
(2) Maintenance code, indicates the lowest
status and source for the listed item. Source codes
category of maintenance authorized to install the
used are:
listed item. The maintenance level codes are:
Explanation
Code
Explanation
Code
P
Applied to repair parts which are stocked in or
O
Organizational maintenance
supplied from DSA/GSA or Army supply
F
Direct maintenance
system, and authorized for use at indicated
H
General support maintenance
maintenance categories.
D
Depot maintenance
