BASIC ISSUE ITEMS LIST AND MAINTENANCE AND OPERATING SUPPLIES
Section I.
INTRODUCTION
(d) X2--applied to repair parts which
1. General
are not stocked. The indicated
Section II lists the accessories, tools, and
maintenance levels requiring such
publications required for maintenance and op-
repair parts will attempt to obtain
eration by the operator, initially issued with,
them through cannibalization; if not
or authorized for the RPV 250 DC20MS1 Air
obtainable through cannibalization,
Compressor. Section III lists the maintenance
such repair parts will be requisi-
and operating supplies required for initial op-
tioned with supporting justification
eration.
through normal supply channels.
(3) Maintenance. The lowest maintenance
2. Explanation of Columns Contained in
level authorized to use, stock, install,
Section II
or manufacture the part is indicated
a. Source Codes. The information provided
by the following code symbol:
in each column is as follows:
O-Organizational Maintenance
(1) Materiel. This column lists the basic
(4) Recoverability. Repair parts and/or
materiel code numbers of the supply
tool and equipment items that are re-
service assigned responsibility for the
coverable are indicated by one of the
part. Blank spaces denote supply re-
following code symbols:
sponsibility of the preparing agency.
(a) R--applied to repair parts and as-
General Engineer supply parts are
semblies which are economically re-
identified by the letters GE in paren-
pairable at direct and general sup-
theses, following the nomenclature in
port maintenance activities and
the description column. Other basic
normally are furnished by supply
materiel code numbers are-
on an exchange basis.
3--Chemical Materiel
(b) T--applied to high-dollar value re-
9--Ordnance Materiel
coverable repair parts which are
10--Quartermaster Materiel
subject to special handling and are
12--Adjutant General
issued on an exchange basis. Such
(2) Source. The selection status and
repair parts normally are repaired
source of supply for each part are in-
or overhauled at depot maintenance
dicated by one of the following code
facilities.
symbols:
(c) U--applied to repair parts specific-
(a) P--applied to high-mortality repair
ally selected for salvage by reclama-
parts which are stocked in or sup-
tion units because of precious metal
plied from the supply service depot
content, critical materials, high-dol-
system, and authorized for use at
lar value reusable casings, castings,
indicated maintenance levels.
and the like.
(b) P1--applied to repair parts which
Note. When no code is shown in the
are low-mortality parts, stocked in
recoverability column the part is con-
or supplied from supply service
sidered expendable.
depots, and authorized for installa-
b. Federal Stock Number. The Federal stock
tion at indicated maintenance levels.
number will be shown in this column, and will
(c) M--applied to repair parts which
be used for requisitioning purposes.
are not procured or stocked but are
c. Description.
to be manufactured at indicated
(1) The item name and a brief description
maintenance levels.
of the part are shown.
AGO 8166A
