e. Installation.
b. Installation.
(1) Install the fuel strainer as illustrated in
(1) Install the engine as illustrated in figure
(2) Fill the fuel tank,
(2) Install and adjust the V-belts (para 67).
(3) Install the V-belt guard (para 66).
60. Fuel Tank
a. Removal.
a. Removal and Disassembly.
(2) Remove the fuel line (para 58).
(1) Stop the engine (para 17).
(3) Remove the fuel tank as illustrated in
(2) Drain the fuel tank.
(3) Remove and disassemble the fuel line as
illustrated in figure 13.
b. Cleaning and Inspection. Clean all parts with
an approved cleaning solvent and dry thoroughly,
b. Cleaning and Inspection.
Inspect all parts for dents or breaks, Inspect the
(1) Clean the fuel line by blowing compressed
nuts and bolts for stripped threads and worn heads.
air through the line. If the line contains
Replace any defective part.
a gummy deposit, soak the line in an ap-
c. Installation.
proved cleaning solvent and dry thor-
oughly.
(1) Install the fuel tank as illustrated in fig-
(2) Inspect the fuel line for cracks, split,
stretched, or frayed ends. Replace the fuel
(2) Install the fuel line (para 58).
line if it is defective.
c. Installation and Reassembly,
(1) Reassemble and install the fuel line as illus-
a. Removal.
trated by figure 13.
(2) Fill the fuel tank,
(2) Remove the V-belt guard (para 66).
(3) Remove the V-belts (para 67).
(4) Remove the drive pulley as illustrated in
a. Removal.
(1) Stop the engine (para 17).
b. Cleaning and Inspection.
(2) Drain the fuel tank.
(1) Clean the pulley and key with an approved
(3) Remove the fuel strainer as illustrated in
cleaning solvent and dry thoroughly.
(2) Inspect the pulley for cracks, and breaks,
b. Disassembly. Disassemble the fuel strainer in
a n d key for chips and burrs, and the
numerical sequence as illustrated in figure 14.
threaded surfaces for wear and damage.
c. Cleaning, Inspection and Repair.
See that the key fits snugly in the keyway.
(1) Clean all parts with an approved cleaning
(3) Replace all defective parts.
solvent. Blow out the fuel strainer' cover
c. Installation.
with compressed air.
(1) Install the drive pulley as illustrated in
(2) Inspect all threaded parts for worn or
damaged threads. Inspect the fuel strainer
(2) Install and adjust the V-belts (para 67).
for damage. I n s p e c t the fuel strainer
cover for cracks. Inspect the bail for bends.
(3) Install the V-belt guard (para 66).
Replace all defective parts.
62. Engine Brackets
d. Reassembly. Reassemble the fuel strainer in
a. Removal.
the reverse of the numerical sequence illustrated in
(1) Remove the gasoline engine (para 57).
