DIRECT AND GENERAL SUPPORT AND DEPOT MAINTENANCE INSTRUCTIONS
Section I.
GENERAL
Commanding General, U.S. Army Mobility Equip-
82. Scope
ment Center, ATTN: SMOME-MPD, 4300 Good-
a. These instructions are published for the use of
63120.
fellow Blvd, St. Louis, Mo.
direct and general support and depot maintenance
c. Report all equipment improvement recommen-
personnel maintaining the air compressor. They pro-
dations as prescribed by TM 38-750.
vide information on the maintenance of the equip-
ment, which is beyond the scope of the tools, equip-
ment, personnel, or supplies normally available to
using organization.
a. DA Form 2258 (Depreservation Guide for
Vehicles and Equipment).
b. The direct reporting, by the individual user,
of errors, omissions, and recommendations for im-
b. For other record and report forms applicable
proving this manual, is authorized and encouraged.
to direct and general support and depot mainte-
DA Form 2028 (Recommended Changes to DA
nance, refer to TM 38-750.
Publications) will be used for reporting these im-
Note. Applicable forms, excluding standard Form 46
provements. This form will be completed using
which is carried by the operator, shall be kept in a canvas
pencil, pen, or typewriter, and forwarded direct to
bag mounted on the equipment.
Section II.
c. Nut and Bolt Torque Data for Compressor.
84. Description
Cylinder flange stud nuts . . . . . . . . . ...45 ft-lb
A general description of the air compressor, the
Cylinder flange studs. . . . . . . . . . . . . ...45 ft-lb
location and description of the identification and
instruction plates, and information on the differences
Unloader to crankcase bolts. . . . . . . ...40 ft-lb
in models are contained in chapter 1, section II, of
Side plate to crankcase bolts. . . . . . ...25 ft-lb
this manual. The repair and maintenance instruc-
Intake manifold stud nuts. ., . . . . . . ..60 ft-lb
tions are described in appropriate sections of this
Intake manifold studs. . . . . . . . . . . . ...60 ft-lb
manual.
Exhaust manifold stud nuts. . . . . . . ...25 ft-lb
85. Tabulated Data
Exhaust manifold studs. . . . . . . . . . . ...25 ft-lb
Connecting rod cap bolt nut. . . . . . . ...25 ft-lb
a. General. This paragraph contains all the over-
haul data pertinent to direct and general support
Flywheel to crankshaft . . . . . . . . . . ...50 ft-lb
and depot maintenance personnel.
b. Engine. For overhaul information see TM
lists manufacturer's sizes, tolerances, desired clear-
5-2805-208-14.
ances, and maximum allowable wear and clearance.
