Table 1. Prescribed Load Listing
15 days organizational
maintenance allowance
Minimum
Unit
Functional
of
stockage
Federal
issue
group
authorization
stock No.
Description
6-10
1-5
(1)
0309
(1)
GASKET: fuel howl (70040)854389
2940-594-2293
4310-911-6608
KIT, EXHAUST VALVE:
high and low pressure (11568) Z122A
(3)
5005
(3)
(1)
compressor drive (25472) 4L570-2
5007
3030-962-2254
BELT, V:
Set
(1)
(7) Subsequent changes to allowances will be
quantity listed in the appropriate end item
limited as follows:
density spread column of 1-5 or 6-10 by
the number of prescribed loads.
(a) No decrease in the stated quantity of
(5) When more than 10 equipments require
Combat Essential items is authorized.
support, multiply the quantity listed in
(b) No change in the range of items is au-
the 6-10 column by the number of equip-
thorized. If exception to the Prescribed
ments and the number of authorized pre-
Load Listing or revision to allowances is
scribed loads, divided by 10, and round to
considered necessary, a recommendation
the nearest whole number.
should be forwarded to the U.S. Army
Example: If the quantity listed in the 6-10
Mobility Equipment Center (para 6).
column is 4, the number of equipments is
(c) Decreases in the stated quantity of items
17, and the number of authorized pre-
other than Combat Essential Items are
scribed loads is 1, the following formula
authorized to a minimum quantity suf-
would be used:
ficient to repair one item and/or assem-
4 x 17 x 1 10 = 6.8
bly and increases in the stated quantity
The resulting fraction is 0.8; therefore the
are authorized for all items when justi-
authorized stockage is 7.
fied by demand and usage experience.
Example: If the quantity listed in the 6-10
Detailed procedures for performing these
column is 4, the number of equipments is
adjustments are prescribed in AR 735-35.
17, and the number of authorized pre-
g. Guide Quantities Per 100 Equipments. Shown
scribed loads is 3, the following formula
for each repair part applicable direct and general
would be used:
support, and/or depot maintenance is either an al-
4 x 17 x 3 10 = 20.4
lowance factor or an asterisk allocation which indi-
cates the following:
The resulting fraction is 0.4; therefore the
authorized stockage is 20.
(1) A guide quantity factor is shown for each
Note. An exception is made for those units
part authorized to be stocked by direct and
a n d organizations required to have on hand,
general support maintenance and supply
boxed or packaged prescribed load(s) pursuant to
support activities, and the number of re-
a special mission assignment. Such prescribed
pair parts recommended for depot mainte-
load(s) will be computed or selected separately
nance. This factor is based on the latest
from quantities authorized for stockage at perma-
mortality data for 1000 hours operation per
nent station,
year and is the average quantity required
(6) Repair parts required to perform organiza-
by the various maintenance activities to
tional maintenance, which are not author-
provide maintenance and supply support
ized for stockage are identified by an
for 100 items of equipment for a 15-day
asterisk, and are to be requisitioned for
period under average combat conditions.
immediate use only.
59
