TM 5-4310-276-14
Section IV. MAINTENANCE PROCEDURES
(1) Clean the air cleaner with cleaning sol-
General
vent, item 5, App. D, and dry thoroughly.
Instructions in this section are published for the
(2) Clean filter element by blowing out with
information and guidance of the operator to main-
air or washing with cleaning solvent, item 5, App.
tain the air compressor.
(3) Inspect the air cleaner for cracks, dents,
A i r Intake Cleaner Assembly
breaks, and other damage.
a. Removal
(4) Replace defective filter element or the
(1) Stop the engine.
complete cleaner assembly if required.
d. Reassembly and Installation.
cylinder head by turning counterclockwise.
(1) Refer to figure 3-3 and
assemble the
com-
b. Disassembly.
pressor air cleaner by installing the filter element
(1) Remove screws (1, fig. 3-3) and
lock-
(4) and cover (3) into base (5) and fastening with
washers (2) attaching air cleaner cover (3) and re-
move cover.
(2) Lift out air cleaner element (4).
bly to cylinder head by turning clockwise.
c. Cleaning and Inspection.
Fuel Tank Strainer
a. Removal.
Dry cleaning solvent, P-D-680, used to
(1) Unscrew fuel tank
filler cap (1, fig. 3-5)
clean parts is potentially dangerous to
counterclockwise until it disengages from fuel tank
personnel and property. Avoid re-
filler opening.
peated and prolonged skin contact.
Do not use near open flame or exces-
sive heat. Flash point of solvent is
100F. (38C.).