TM 5-4310-276-14
Table 4-2. Troobleshooting (cont)
Malfunction
Test or Inspection
Corrrective Action
(1) Clean carburetor with drycleaning solvent, item 5, App. D, and dry with low pressure fil-
tered air.
(2) Inspect carburetor body for cracks, breaks, evidence of leakage, stripped or damaged
threads or other damage.
(3) Inspect throttle rod and connectors, butterflies and housings for cracks, breaks, wear and
ease of operation.
(4) Inspect adjustment screws for stripped or damaged threads, bent or broken ends.
(5) Inspect to see that all plugs are tightened and not leaking.
(6) Inspect throttle mounting plates for cracks, breaks, or other damage.
(7) Inspect throttle control for proper operation.
(8) Repair or replace any damaged or defective wear.
c. Installation.
(1) Use figure 4-5 for Model 1A08-1 and figure 4-6 for Model and throttle controls.
NOTE
When installing throttle lever on Models 1A08-2 and 1A08-3 be sure punch mark is pointed up and out.
(2) Spread control rod clevis and install throttle lever.
(3) Install new gaskets and rear cover to throttle housing. Install the throttle housing to
carburetor.
(4) Using a new gasket, install the carburetor onto the intake manifold. Using an inch pound
torque wrench, torgue the carburetor mounting nuts to intake manifold to 60-85 inch-pounds.
(5) Install the air cleaner elbow duct to carburetor.
(6) Install the fuel line to the carburetor.
(7) Reconnect throttle lever to the shaft.
(8) Install front throttle housing gasket and the housing.
d. Adjustment.
(1) Using figure 4-7 as a guide, adjust the carburetor.
4-11
