TM 5-4310-276-14
Table 4-2. Troubleshooting (cont)
Malfunction
Test or Inspection
Corrective Action
continuity from the terminal and to the capacitor case or mounting lug. No continuity should
be indicated. If so, discard capacitor. Check the lead for damage, fraying or damaged or bro-
ken terminal end.
(2) Repair or replace any damaged or defective part.
c. Installation.
(1) Refer to figure 4-9 and install the capacitor.
(2) Install the accessory case cover.
Step 7. Inspect for grounded ignition cable.
Replace cable, or locate grounded point and tape for temporary operation.
a. Removal.
(2) Loosen the connector nut on each end of the cable and remove the cable.
b. Inspection.
(1) Inspect the braided cables for broken, torn or cut strands.
(2) Inspect connector bodies for cracks, breaks and springs for broken or distorted coils.
(3) Inspect connectors for stripped or damaged threads or distorted nuts.
c. Repair or Replacement.
(1) Repair or replace the spring tips.
(2) Replace rubber insulators around the springs if torn or damaged.
(3) Replace ignition cable if damaged.
d. Installation.
(1) Use figure 4-8 as guide and install ignition cable.
(2) Tighten connector nuts on each end of cable.
2. ENGINE MISSES OR OPERATES ERRATICALLY.
Step 1. Inspect for clogged vent in fuel tank cap.
Clean cap vent, take out vent screw, and blow out with compressed air.
Step 2. Inspect for clogged carburetor air intake screen.
Service the air cleaner.
a. Service (Models 1A08-1 and 1A08-2).
(1) Loosen retaining clamps and mounting clamp. (fig. 4-11)
4-16