TM 5-4310-277-14
(2) Inspect all valve seats and cages for cracks,
b. Cleaning and Inspection.
breaks, rough or scored seats, and mating surfaces.
Replace if defective.
Dry cleaning solvent, P-D-680, used to clean
(3) Inspect the springs for distortion, weakness,
parts is potentially dangerous to personnel
or broken coils. Replace if defective.
and property. Avoid repeated and
(4) Replace all gaskets each time valves are
prolonged skin contact. Do not use near
removed or disassembled.
open flame or excessive heat. Flash point of
c. Assembly and Installation.
solvent is 100 F. (38C.) - 138 F. (59 C.).
(1) Reassemble and install the intake and
(1) Clean all parts with cleaning solvent, Federal
exhaust valves as follows:
Specification P-D-680, and dry thoroughly.
4-38.1/(4-38.2Blank)
Change 1
