TM 5-4310-278-15
pressor is to be transported by carrier, block
(2) Disconnect exhaust pipe extension if
used.
or tie it to the carrier to prevent it from shift-
(3) Remove plug from bottom of fuel
ing while being transported.
tank and drain fuel into suitable container.
(4) Cover opening of outlet adapters with
adapter plugs (fig. 1-1) to protect adapters
carrier, install bands through frame. Do not
and prevent foreign matter from entering ro-
secure by banding across channels.
tary compressor.
b. Preparation for Movement.
(1) Disconnect outlet hoses from outlet
Refer to paragraph 2-4 for installation and
adapters, Stow hoses as shown in figure 1-1.
setting-up procedures.
Disconnect and stow inflator valves in tool box.
CONTROLS
Section III.
about the various controls for proper operation
General
of the rotary compressor.
This section describes, locates, illustrates, and
2-8. Controls
furnishes the operator, crew, or organizational
The purpose of controls and their normal and
maintenance personnel sufficient information
maximum reading are illustrated in figure 2-1.
