TM 5-4310-278-15
OPERATOR AND ORGANIZATIONAL MAINTENCE
INSTRUCTIONS
Section I. OPERATOR AND ORGANIZATIONAL
MAINTENANCE TOOLS AND EQUIPMENT
for the rotary compressor are listed in the basic
issue items list, appendix C of this manual.
The special tools required to perform organi-
zational maintenance on the rotary compressor
engine are listed in TM 5-2805-208-14. Refer-
ence to a paragraph and the use of these tools
Parts
are listed in the table. No special equipment
is required by organizational maintenance for
Organizational maintenance repair pars for
performing maintenance of the rotary com-
the rotary compressor are listed and illustrated
pressor.
in TM 5-4310-278-25P, (when printed). Re-
pair parts for the engine are listed in TM 5-
2805-208-14.
Tools and repair parts issued with or authorized
Section II.
LUBRICATION
lubricating the equipment, wipe all lubrication
points free of dirt and grease. Clean all lubri-
a. This section contains instructions which
cation points after lubrication to prevent ac-
are supplemental to, and not specifically
cumulation of foreign matter.
covered in the lubrication order.
c. Points of Lubrication. Service the lubri-
b. The lubrication order is a reproduction of
cation points as illustrated in figure 3-1.
the approved lubrication order for the rotary
compressor. For the current lubrication order,
d. Rotary Compressor Lubrication. Main-
Refer to DA Pamphlet 310-4.
tain oil to midpoint level of sight gages on
rotary compressor. To change oil in rotary com-
pressor, remove drain plugs and drain. Install
drain plugs and remove breathers. Pour oil in-
tainers and store in a clean, dry place away
to breather port until oil is level with the mid-
from external heat. Allow no dirt, dust, or
point of the sight level gages on the compressor.
other foreign material to mix with the lubri-
Install breathers. Refer to lubrication order for
cants. Keep all lubrication equipment clean and
lubrication interval and type of oil required.
ready for use.
e. Refer to TM 5-2805-208-14 for engine
b. Cleaning. Keep all external parts not re-
lubrication instructions.
quiring lubrication free of lubricants. Before
