TM 5-4310-343-35
c. Moisture Separator
(1) Refer to figure 6-1 and proceed as follows.
(2) Removal.
Loosen strap clamps (5) on bracket separator (10).
Disconnect moisture separator (9) from
valve (20) by loosening nut (6). Remove moisture separator (9).
d. Back Pressure Valve
(1) Refer to figure 6-1 and proceed as follows.
(2) Removal. 'Loosen union (21) and nut (6). Remove back pressure valve (20).
e. Pressure Switch Relief Module
(1) Refer to figure 6-1 and proceed as follows.
(2) Removal. Remove two bolts (34), flat washers (35), lock washers (36) from clamp plates (33).
(3) Disconnect wiring and lift off pressure switch relief module (40).
f. 2nd Stage Relief Valve.
(1) Refer to figure 6-1 and proceed as follows.
(2) Removal. Disassemble end nut of second stage intercooler (97); then, unscrew entire relief valve assembly
(99) from third stage of basic compressor (159).
g. Oil Pump.
(1) Refer to figure 6-1 and proceed as follows.
(2) Disassemble four pump screws (0) and remove screws, flat washers (71), rear fan guard (69) and oil pump
(112) from air compressor.
5-9
