TM 5-4310-343-35
Section IV. OVERHAUL
5-7.
General
This section contains overhaul instructions for repairable assemblies of air compressor part no. 895026.
5-8.
Disassembly
a. Moisture Separator
(1) Disassembly
(a) Refer to paragraph 5-6.c. for removal instructions.
(b) Refer to figure 6-2 and disassemble moisture separator as follows:
(1) Peel off cap tape (1), unscrew safety plug ), and lift off safety disc ring (3), safety disc (4), and safety disc
retainer (5).
(2) Unscrew plug (6) with packing O-ring (7) from shell (10).
(3) Loosen lock nut (11) and unscrew body (34) from shell (10).
(4) Remove baffle (8) from Inside shell (10).
(5) Remove locknut (11), back-up ring (13), and packing O-ring (12) from body (34).
(6) Unscrew seat (15) and packing O-ring (16).
(7) Unscrew cylinder bleed valve (18) and lift off seat assembly (19), packing O-ring (20), and spring (21). Inlet
tube (14) is secured in place with locktite sealant MIL-S-22473.
(8) Remove mounting block (28) together with thermostat (22) and connector (25), by removing screws (23 and
26). Heater (31) is cemented in position on body (34) with litharge and glycerine cement. Do not remove thermostat (22)
or connector (25) from mounting block (8) unless required for replacement of either part.
5-13
