TM 5-4310-343-35
(6) Blow compressed air through oil strainer (80) to dislodge any foreign particles from screen.
(7) Inspection. Inspect oil strainer for defective screen and threads.
(8) Inspect all threaded components for defective or damaged threads.
(9) Check all removed components for distortion and damage.
(10) Replacement. Replace preformed packings (102, 143, and 150), dipstick (142), and tube (92).
(11) Installation. Installation is the reverse of removal, refer to preceding steps ( through 4). Apply torque as
applicable; refer to paragraph 5-4.
I. Dump Timer.
(1) Refer to figure 6-1 and proceed as follows.
(2) Disconnect electrical connections from timer (57).
(3) Unscrew screws (58), washers (59), and nuts (60), and lift off dump timer.
NOTE: Do not attempt to repair dump timer. If dump timer is defective, replace it
as a complete assembly.
j. Motor.
(1) Refer to figure 6-1 and proceed as follows.
(2) Removal. Unscrew electrical connection nuts and lift off connection cables.
(3) Remove nuts (158), bolts (156), and flat washers (157) and slide motor out and away from compressor
assembly. Remove gasket (155) and shaft (126).
5-11
