TM 5-4310-352-14
Figure 3-2. Belt guard assembly, removal and installation.
b. Inspection. Inspect for damage to screen,
WARNING
bends, dents, or other damage to belt guard panels.
Dry cleaning solvent, P-D-680, used to
Check for accumulation of grease soaked dust, dirt, or
clean parts is potentially dangerous to
other foreign matter. Remove dirty guard for cleaning.
personnel and property. Do not use
Remove a damaged guard for straightening, or replace-
near open flame or excessive heat.
ment.
Flash point of solvent is 100 (38 ) -
F
C
c. Removal. Turn off power at source and lock it
0
0
138 F (59 C).
out.
(1) Clean belt guard with a rag dipped in
(1) Remove capscrew (2), and lockwasher (3),
cleaning solvent Fed. Spec. P-DA80, then wipe dry.
and flatwasher (4) from brace (5).
(2) Smooth out any dents or bends. Replace
(2) Remove two capscrews (7), lockwashers
any damaged part that is beyond repair.
(8), and flatwashers (9). Remove the two spacers (11 and
e. Installation.
10) from each capscrew (7).
(1) Position rear belt guard (15) and secure
(3) Remove two thread forming screws (6) and
with lockwasher (14) and capscrew (13).
lift front belt guard (12) off the belts.
(2) Install front belt guard (12) and secure with
(4) Remove capscrew (13), lockwasher (14),
screws (6), spacers (10 and 11), flatwashers (9), lock-
then lift rear belt guard (15) off the receiver. Do not re-
washers (8) and capscrews (7).
move brace (5) from cylinder head unless damaged.
(3) Position brace (5) and secure with flat-
d. Cleaning and Replacement.
washers (4) lockwashers (3) and capscrews (2).
3-7
