TM 5-4310-354-14
3-14. Air Cleaner Service. Service the air cleaners,
both engine and compressor, as shown in figure 3-12.
TS5-4310-354-14/3-12
NOTE
STEP 4.
CLEAN CUP ASSEMBLY WITH SOLVENT,
FED SPEC P-D-680, TYPE II, OR
THE
FOLLOWING
SERVICE
EQUIVALENT, AND DRY THOROUGHLY.
INSTRUCTIONS APPLY TO BOTH
ENGINE AND COMPRESSOR AIR
STEP 5.
REFER
ELEMENT
CLEANING
TO
CLEANERS. DO NOT SERVICE AIR
ORGANIZATIONAL MAINTENANCE.
CLEANERS
WHILE
ENGINE
IS
OPERATING.
STEP 6.
INSTALL CLEAN ELEMENT IN AIR
CLEANER BODY ASSEMBLY. SECURE
STEP 1.
LOOSEN CLAMP THAT SECURES THE
IN PLACE WITH GASKET AND WING
CUP
ASSEMBLY
TO
THE
BODY
BOLT.
ASSEMBLY.
STEP 7.
INSTALL CUP ASSEMBLY AND SECURE
STEP 2.
PULL CUP ASSEMBLY OUTWARD AND
TO BODY ASSEMBLY WITH CLAMP.
REMOVE FROM UNIT. REMOVE WING
BOLT AND GASKET THAT SECURES
NOTE
ELEMENT
IN
BODY
ASSEMBLY.
REMOVE THE ELEMENT.
INSTALL CUP ASSEMBLY WITH
ARROWS POINTING UPWARD.
NOTE
STEP 8.
RESET RESTRICTION INDICATORS ON
DO NOT CLEAN INSIDE OF BODY
INSTRUMENT PANEL BY PRESSING
ASSEMBLY
WITH
COMPRESSED
DOWN ON INDICATOR TOP RESET
AIR.
UNTIL INDICATOR WINDOW SHOWS
GREEN. (FIG 2-3.)
STEP 3.
CLEAN
THE
INSIDE
OF
BODY
ASSEMBLY WITH CLEAN, LINT-FREE
CLOTH MOISTENED WITH SOLVENT,
FED
SPEC
P-D-680,
TYPE
II,OR
EQUIVALENT. WIPE DRY WITH CLEAN
CLOTH
Figure 3-12. Air cleaner service.
3-15
