TM 5-4310-354-14
3-16. Quick Start Assembly Service. Service the
quick start assembly as shown in figure 3-14.
WARNING
DO NOT PUNCTURE OR MISHANDLE
FUEL CYLINDER. THE CONTENTS
OF THE CYLINDER IS AN ETHER
BASE
MIXTURE
WHICH
IS
EXTREMELY TOXIC, VOLATILE, AND
COMBUSTIBLE.
STEP 1.
REMOVE WINGNUTS, LOCKWASHERS,
AND CLAMP.
STEP 2.
UNSCREWAND
REMOVE
FUEL
CYLINDER FROM ACTUATING VALVE
ASSEMBLY. COVER VALVE OPENING
WITH CAP UNTIL READY TO INSTALL
NEW FUEL CYLINDER.
STEP 3.
REMOVE VALVE CAP AND INSTALL
NEW GASKET AND NEW CYLINDER.
TIGHTEN CYLINDER IN VALVE HAND
TIGHT ONLY. DO NOT OVER TIGHTEN.
STEP 4.
INSTALL CLAMP, LOCKWASHERS, AND
WINGNUTS.
TS5-4310-354-14/3-14
Figure 3-14. Quick start assembly service.
3-17. Safety Valve Service . Service the oil separator
safety valve as shown in figure 3-15.
STEP 1.
CHECK OPERATION OF SAFETY VALVE
WHILE UNIT IS RUNNING.
PULL
ACTUATING
RING
OUTWARD
MOMENTARILY AND RELEASE. VALVE
SHOULD CLOSE COMPLETELY.
STEP 2.
IN AN EMERGENCY, THE SAFETY
VALVE MAY BE USED TO RELIEVE
PRESSURE IN OIL SEPARATOR SHOULD
TS5-4310-354-14/3-15
THE BLOWDOWN VALVE FAIL.
Figure 3-15. Safety valve service.
3-17
