TM 5-4310-358-14
LO 5-4310-358-12
LUBRICATION ORDER
LO 5-4310-358-12
COMPRESSOR, AIR, TANK MOUNTED, ELECTRIC MOTOR DRIVEN,
5 CFM AT 175 PSI CHAMPIOM MODEL NO. HR2-6M-2
Intervals and related task-hour times are bases
Clean fittings before lubricating. Relubricate all
on normal hours of operation. The task-hour
areas exposed to water after amphibious
time specified is the time you need to do all the
operation. Lubricate points indicated by dotted
services prescribed for a particular interval.
arrow shaft on both sides of equipment. Clean
Change the interval if your lubricants are
parts with SOLVENT, dry cleaning, or with OIL,
contaminated or if you are operating the
fuel, diesel.
Dry before lubricating.
Drain
equipment under adverse operating conditions,
crankcases when HOT. Fill and check level.
including longer-than-usual operating hours.
The lowest level of maintenance authorized to
You may extend the interval during periods of
lubricate a point is indicated by one of the
low activity, but you must take adequate
following:
(c)
operator/crew,
or
(O)
preservation precautions.
organizational maintenance.
*The time specified is the time required to
perform all services at the particular interval.
FOLD
FOLD
(Figure 3-1 Sheet 1 of 2)
(Figure 3-1 Sheet 2 of 2)
*TOTAL TASK HOURS
*TOTAL TASK HOURS
INTERVAL
TASK HOURS
INTERVAL
TASK HOURS
10
0.1
500
0.5
50
0.25
Figure 3-1. Lubrication Order (Sheet 1 of 2)
STS Form 2273
Previous edition is obsolete
1 Dec 76
3-2
