TM 5-4310-360-14
CHAPTER 5
DIRECT AND GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS
AND EQUIPMENT
Special Tools and Equipment.
5-3.
Fabricated Tools and Equipment.
5-1.
No specially fabricated tools and equipment are
No special tools are required to perform direct and
required by direct and general support mainte-
general support maintenance on the compressor.
nance personnel to perform maintenance on the
compressor.
5-2.
Repair Parts.
Repair parts are listed and illustrated in the repair
parts and special tools list TM 5-4310-310-24P,
and TM 5-2805-256-24P (Engine).
Section II. TROUBLESHOOTING
b.
This manual cannot list all malfunctions
5-4. General.
that may occur, nor all tests or inspections
and corrective actions. If a malfunction is
This section contains troubleshooting
a.
not listed or is not corrected by listed cor
information for locating and correcting most
rective actions, notify your supervisor.
of the operating troubles which may develop
in the compressor. Each malfunction for an
individual component, unit, or system is fol-
5-5.
Direct and General Support Maintenance
lowed by a list of tests or inspections which
Troubleshooting.
will help you to determine corrective actions
to take. You should perform the tests/
inspections and corrective actions in the
tion.
order listed.
5-1
