TM 5-4310-362-14
Section III. MAINTENANCE PROCEDURES
3-5. INTRODUCTION
This section covers maintenance procedures that the operator has to perform.
LOCATION 1 ITEM
ACTION
REMARKS
3-6. OPERATORS
MAINTENANCE
1. Belt guard assembly (1)
Inspect for loose mounting
hardware. Tighten if necessary.
WARNING
Disconnect main power
before inspecting belts
and pulleys to avoid un-
expected starting of the
2. V-Belts (2)
a. Inspect for cracks, proper
tension and alinement.
b. Notify organizational
maintenance if belts are
defective.
3. Drive pulley (3)
a. Inspect for looseness.
b. Tighten set screw if loose.
4. Air cleaner element (4)
a. Remove.
b. Inspect for dirt.
WARNING
Air pressure must not
exceed 30 psi when
cleaning. Gloves or
other skin protection
must be used when
working with cleaning
solvents.
c. Clean Model 20-904 with air
Clean Model 20-911 with
solvent
d. Inspect for tears or holes.
e. Replace element if defective.
Change 1 3-7
