TM 5-4310-368-14
(8)
Disconnect clutch linkage at clutch.
(9)
Attach lifting device beneath exhaust manifold.
(10)
Disconnect oil drain line at engine.
(11)
Disconnect air cleaner tube at carburetor. (Figure 6-6)
(12)
Remove engine from frame.
6-5.DISASSEMBLY
a. Starter. Remove starter. (Fig. 6-7)
(1) Disconnect starter cable at the starter.
(2) Remove two nuts and lock washers.
(3) Remove starter support bracket.
(4) Remove three bolts and lock washers. Remove the starter.
b. Clutch. Remove clutch. (Fig. 6-8)
(1) Remove three bolts and lock washers from drive sheave bushing.
(2) Insert two bolts into threaded holes in bushing. Tighten bolts to push drive sheave off of bushing.
(3) Remove bushing, drive sheave and shaft key from output shaft.
c.
Magneto. Remove magneto (Fig. 6-9)
(1) Disconnect four spark plug wires.
(2) Disconnect ground strap.
(3) Disconnect main wire harness at one place.
(4) Remove nut.
(5) Remove bolt, lock washers and nut.
(6) Remove magneto.
(1) Remove two bolts, two nuts and four washers. Remove seal clamp.
(3) Remove four nuts and four washers.
(4) Remove intake and exhaust manifold assembly.
6-3
