TM 5-4310-368-14
(2) Install fuel tank (paragraph 5-5).
(3) Install axle (paragraph 5-4).
(4) Install heater (paragraph 5-27).
(5) Install compressor (paragraph 5-3).
(6) Install engine (paragraph 5-2).
(7) Start engine and compressor. Check for leaks, belt chafing, etc. Repair as required.
5-27.
COMPARTMENT HEATER
This task covers:
a. Removal
d. Inspection
b. Disassembly
e. Reassembly
c.
Cleaning
f.
Installation
INITIAL SETUP
Applicable Configurations
All
General Safety Precautions
WARNING
Dry cleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel
and property. Avoid repeated and prolonged skin contact. Do not use near open flame
or excessive heat. Flash point of solvent is 100 (38 ) - 138 (59 ).
F
C
F
C
a. Removal
(1) Disconnect wire assembly at heater.
(2) Disconnect fuel line at heater.
(3) Disconnect three air ducts at heater.
(4) Remove two straps, two bolts, four nuts and four washers.
(5) Lift heater slightly and remove exhaust pipe.
(6) Remove heater from frame.
5-50
