TM 5-4310-368-14
d.
Press shaft seal (23) into cover (24).
e.
Slide cover (24) with gasket (27) onto eccentric shaft (30).
f.
Place three washers (26) on three hex-head screws (25) and screw through cover (24) into lower part of
crankcase (31). Tighten to 7-8 lb-ft.
6-64.
a.
Accomplish necessary prerequisites (see Figure 6-54).
b.
Place gasket (18) on oil pump (13).
c.
Place three washers (15) on three internal hex-head screws (14) and screw through oil pump (13) into lower
part of crankcase.
d.
Tighten internal hex-head screws (14) to 18 lb-ft.
e.
Insert 0.3 mm or .012 in. feeler gage between eccenter and pump plunger and turn eccenter shaft by hand. If
eccenter does not turn place an additional gasket between oil pump (13) and lower part of crankcase. Pump
plunger must lie against eccenter with no free space between.
6-65.
a.
Brush gasket (11) (Figure 6-52) with non-setting sealing material and place on lower part of crankcase (31).
Place upper part of crankcase (37) (Figure 6-47) on lower part of crankcase.
b.
Place seven washers (10) (Figure 6-52) on studs (8). Fasten upper part of crankcase (37) (Figure 6-47) to
lower part of crankcase (31) (Figure 6-52) with seven hex nuts (9) (Figure 6-52). Tighten down evenly to 18
lb-ft.
c.
Place gasket (34) (Figure 6-47) on dipstick tube (33) and screw dipstick tube into upper part of crankcase (37).
Tighten to 25.8 lb-ft.
d.
Slide O-ring (32) (Figure 6-47) onto dipstick (31) and insert dipstick into dipstick tube (33).
e.
Place gasket (36) (Figure 6-47) on internal hex-head screw (35) and screw into upper part of crankcase (37).
Tighten to 20 lb-ft.
6-66.
a.
Place needle bearing case (8) on driving gear (7). Slide connecting rod 3rd stage (14) onto needle bearing
case.
b.
Place one spacer (15) and next needle bearing cage (8) on driving gear (7) and slide connecting rod 4th stage
(13) onto needle bearing cage.
c.
Place one spacer (15) and next needle bearing case (8) on driving gear (7) and slide connecting rod 1st stage
(12) onto needle bearing case.
d.
Place two spacers (15) and next needle bearing case (8) on driving gear (7) and slide connecting rod 2nd
stage (11) onto needle bearing case.
6-61
