TM 5-4310-368-14
Figure 6-32. Cylinder Head Bolt Tightening Sequence
(10) Install three 1/4-20" screws and lock washers into left rear shroud cover.
(11) Install right cylinder head shroud.
(12) Install left cylinder head shroud.
(13) Install six 1/4-20" screws and lock washers into right cylinder head shroud.
(14) Install six 1/4-20" screws and lock washers with left cylinder head shroud.
n.
Flywheel. Install flywheel (Figure 6-11).
(1)
Verify installation of woodruff key in crankshaft.
(2)
Position flywheel over end of crankshaft. Align keyway in flywheel bore with woodruff key. Install
flywheel.
(3)
Secure flywheel with nut and washer.
(4)
Install starting crank pin.
o.
Flywheel Screen
(1)
Install flywheel screen.
(2)
Examine starter ring gear. If damaged, press off old gear.
6-27
