TM 5-4310-368-14
6-83.
a. Accomplish necessary prerequisites (see Figure 6-54).
b. Oil cylinder track.
c.
Screw four studs (35) into upper part of crankcase.
d. Slip O-ring (19) onto cylinder (16).
e. Place cylinder (16) with floating piston (20) on upper part of the crankcase with a cylinder head bolt hole in
the 12 o'clock position. Place washers (18) on the studs (35).
f.
Attach cylinder (16) with four hex nuts (17). Tighten nuts to a torque of 18 lb-ft.
6-84.
a. Accomplish necessary prerequisites (see Figure 6-54).
b. Screw four studs (35) into upper part of crankcase.
c.
Slip O-ring (19) into oil cylinder track of cylinder (13).
d. Press four piston rings (11) into piston-ring slots of the piston (9).
e. Slide cylinder (13) carefully over piston (9) and place cylinder on upper part of crankcase.
f.
Place washers (15) on the studs (35), attach cylinder (13) with four hex nuts (14). Tighten to a torque of 18
lb-ft.
6-85.
a. Accomplish necessary prerequisites (see Figure 6-54).
b. Screw four studs (35) into upper part of crankcase.
c.
Slip O-ring (6) onto cylinder (3), oil cylinder track.
d. Slide cylinder (3) carefully over piston (1). When all piston rings are covered by the cylinder, place cylinder
on upper part of crankcase.
e. Place washers (5) on the studs (35), attach cylinder (3) with four hex nuts (4). Tighten nuts to a torque of 18
lb-ft.
6-86.
a. Slip O-ring (35) onto discharge valve (34).
b. Press discharge valve (34) into valve head (36).
6-67
