TM 5-4310-368-14
a. Screw extension pipe (24) into upper part of crankcase (37).
b. Place gasket (23) on extension (24) and screw demister body (22) into extension.
c.
Place gasket (21) on demister body (22) and cover with demister top (20).
d. Mount four retaining clips (19).
e. Place O-ring (16) in cover plug (15), screw cover plug into demister top (20).
f.
Slide two hose clamps (17) onto vent hose (18).
g. Place vent hose (18) on inlet connection of the 1st stage and on demister top (20) and tighten hose clamp.
a. Accomplish necessary prerequisites (see Figure 6-54).
b. For 3rd to 4th stage intercooler (32) place two washers (23) on two internal hex-head screws (22). Place
against upper part of crankcase (37, Figure 6-47) and insert internal hex-head screws (22) with washers (23)
through finned tube clamp (21) and upper part of crankcase. Place washers (23) on internal hex-head
screws (22), screw on hex nuts (24), place lock washer (26) on internal hex-head screw (25), insert internal
hex-head screw through finned tube clamp (21) into upper part of crankcase. Tighten hex nuts (24) and
internal hex-head screw (25) with a torque of 18 lb-ft.
c.
Screw three studs (29) into finned tube clamp (21), place intercooler 3rd to 4th stage (32) and finned tube
clamp (27). Place washers (30) on studs (29), screw on hex nuts (28). Tighten nuts with a torque of 8 lb-ft.
d. Mount one plate spring (19) for each of the three hex-head screws (17), insert screws through finned tube
clamp (16). Place finned tube clamp on intercooler 3rd to 4th stage (32). Place other finned tube clamp (16)
and seven plate springs (19) on each of the three hex-head screws (17) and screw on hex nuts (18). Tighten
hex nuts (18) to a torque of 3 lb-ft.
e. Screw two intercooler tubes (32) to the valve head of the 3rd stage and filter head 3rd to 4th stage and
tighten with a torque of 23 lb-ft.
f.
For intercooler 2nd to 3rd stage, place two washers on two internal hex-head screws (22). Place finned tube
clamp (21) on upper part of crankcase (37, Figure 6-47) and insert internal hex-head screws (22) through
finned tube clamp and upper part of crankcase. Place washers (23) on internal hex-head screws (22) and
screw on hex nuts (24). Place lock washer (26) on internal hex-head screw (25), insert internal hex-head
screw through finned tube clamp (21) into upper part of crankcase. Tighten hex nut (24) and internal hex-
head screw (22) with a torque of 18 lb-ft.
g. Screw three studs (29) into finned tube clamp (21). Place intercooler 2nd to 3rd stage (31) and finned tube
clamp (27) on finned tube clamp (21). Place washers (30) on the studs (29), screw on hex nuts (28). Tighten
with a torque of 8 lb-ft.
6-71
