TM 5-4310-369-14
COMPONENTS OF END ITEMS LIST
Section I. INTRODUCTION
b. National Stock Number (NSN). Indicates the national
E-1.
Scope
stock number assigned to the end item which will be used
This appendix lists Integral Components of and Basic
for requisitioning.
Issue Items (BII) for the Air Compressor to help you
c. Part Number (P/N). Indicates the primary number
inventory items required for safe and efficient operation.
used by the manufacturer which controls the design and
E-2. General
characteristics of the item by means of its engineering
The components of end list are divided into the following
drawings, specifications, standards and inspection require-
sections.
ments to identify an item or range of items.
a. Section II. Integral Components of the End Item.
d. Description. Indicates the federal item name and, if
These items, when assembled, comprise the Air Compressor
required, a minimum description to identify the item.
and must accompany it whenever it is transferred or turned
e. Location. The physical location of each item is
in. These illustrations will help you identify these items.
given in this column. The lists are designed to inventory
b. Section III. Basic Issue Items. These are minimum
all items in one area of the major item before moving on
essential items required to place the Air Compressor in
to an adjacent area.
operation, to operate it and to perform emergency repairs.
f. Usable on Code. (Not Used.)
Although shipped separately packed, they must accompany
g. Quantity Required (Qty Reqd). This column lists
the Air Compressor during operation and whenever it is
the quantity of each item required for a complete major
transferred between accountable officers. The illustrations
item.
will assist you with hard-to-identify items. This manual is
h. Quantity. This column is left blank for use during
your authority to requisition replacement BII based on
inventory. Under the received column, list the quantity
Table(s) of Organization and Equipment (TOE)/Modification
you actually receive on your major item. The date columns
Table of Organization and Equipment (MTOE) authorization
are for use when you inventory the major item at a later
of the end item.
date, such as for shipment to another site.
Explanation of Columns
E-3.
a. Illustration. This column is divided as follows:
(1) Figure Number. Indicates the figure number of
the illustration on which the item is shown (if applicable).
(2) Item Number. The number used to identify item
called out in the illustration.
Section II. INTEGRAL COMPONENTS OF END ITEM
