TM 5-4310-370-14
(4) Repair or replace any unserviceable parts.
c. Motor Reassembly
(1) Replace rotor and shaft assembly (figure 5-1, item 22) into stator (figure 5-1, item 23).
(2) Replace switches (figure 5-1, item 20) and hold in place by tightening down switch screws
(3) Replace capacitors (figure 5-1, item 18) and the capacitor wire sleeve (figure 5-1, item 19).
(4) Replace capacitor box (figure 5-1, item 15) by turning capacitor box screws (figure 5-1, item 16) counter
clockwise on to stator (figure 5-1, item 23) after positioning capacitor box pad (figure 5-1, item 17) in place.
(5) Replace front fan (figure 5-1, item 13) and hold in place by tightening fan screw (figure 5-1, item 14).
(6)
Replace balance washer (figure 5-1, item 12).
(7) Replace FR. bearing (figure 5-1, item 10) and install wavy washer (figure 5-1, item 11).
(8) Replace PU. bearing (figu re 5-1, item 9).
(9) Replace FR. end plate (figure 5-1, item 8) on to stator (figure 5-1, item 23) and hold in position by
reinsertion of thru bolts (figure 5-1, item 7).
(10) Replace rear fan (figure 5-1, item 5) and hold in place by tightening fan screw (figure 5-1, item 6).
(11) Replace PU. end plate (figure 5-1, item 4) and hold in place by tightening thru bolt nuts (figure 5-1, item 3).
(12) Replace rear housing (figure 5-1, item 1) and tighten housing screws, (figure 5-1, item 2).
d. Rotor Assembly Inspection and Replacement
(1) Inspection check to see if rotor rings (windings) are spotted, rough, eccentric, or broken. If any of these
conditions exist, the rotor assembly must be replaced.
(2) Replacement replace rotor assembly in accordance with procedures described in paragraph 5-2a.
e. Stator Assembly Inspection and Replacement
5-11
