TM 5-4310-371-14
(a) Install low pressure piston ring set(s) (figure 5-7, item 13)
(b) Install high pressure piston ring set(s) (figure 5-7, item 12)
(c) Install oil dippers (figure 5-7, item 11) by pressing them into bottom of connecting rods (figure 5-7,
item 9)
(d) Install piston pin bearing (figure 5-7, item 10)
(e) Install connecting rods (figure 5-7, item 9) by bolting them together around crankshaft using
connecting rod bolts (figure 5-7, item 8) tightened each to 230 in. lbs. (41,078 gr. cm).
(2) Pistons
(a) Install on to connecting rods low pressure piston (figure 5-7, item 7)
and high pressure piston
(b) Install piston pin (figure 5-7, item 5).
(c) Install piston pin retaining rings (figure 5-7, item 4).
(3) Cylinders
(a) Replace cylinder flange gasket (figure 5-7, item 3), and install gasket and cylinder (figure 5-7, item 2).
(b) Install hex steel cap screws (figure 5-7, item 1) and tighten to 470 in. lbs. (83,942 gr. cm).
5-6. GOVERNOR AND RELEASE VALVE ASSEMBLY
a. Disassembly
(1) Release Valve Assembly
(a) Turn release valve cap (figure 5-7, item 7) until it is removed.
(b) Remove release valve spring (figure 5-8, item 2).
(c) Remove release valve ball (figure 5-8, item 3).
(d) Remove release valve body (figu re 5-8, item 4).
(e) Remove release valve body gasket (figure 5-8, item 5).
(f) Remove release valve plunger sleeve (figure 5-8, item 6).
(g) Remove release valve plunger (figure 5-8, item 7).
(2) Governor
(a) Turn fillister head machine screws (8) (figure 5-8, item 8) counter clockwise until removed.
5-28
