TM 5-4310-371-14
(b) Install new governor housing gasket set (figure 5-8, item 22) and reinstall upper governor housing
(c) Install hex steel cap screws (4) (figure 5-8, item 19) and torque to 550 in. lbs. (98,23 gr. cm). Install
governor baffle plate (figure 5-8, item 20) at this time.
(2) Release Valve Assembly
(a) Install release valve plunger (figure 5-8, item 7).
(b) Install release valve plunger sleeve (figure 5-8, item 7).
(c) Install release valve body gasket (figure 5-8, item 5).
(d) Install release valve body (figure 5-8, item 4).
(e) Install release valve ball (figure 5-8, item 3).
(f) Install release valve spring (figure 5-8, item 2).
(g) Install release valve cap (figure 5-8, item 1).
(3) Governor
(a) Install governor weight spindle (figure 5-8, item 18).
(b) Install governor weight (figure 5-8, item 17).
(c) Install governor weight pins (figure 5-8, item 16).
(d) Install spring lockwasher (figure 5-8, item 15).
(e) Install hex steel cap screw (figure 5-8, item 14).
(f) Install flat steel washer (figure 5-8, item 13).
(g) Install governor main spring (figure 5-8, item 12).
(h) Install spring sleeve (figure 5-8, item 11)
(j) Install governor cover gasket (figure 5-8, item 10).
(k) Install governor housing cover (figure 5-8, item 9).
(l) Install fillister head machine screws (8) (figure 5-8, item 8).
5-7. CRANKCASE ASSEMBLY.
a. Disassembly
(1) If visible sight oil level gage (figure 5-9, item 1) is damaged in any way, remove by prying it out.
5-31
