TM 5-4310-372-14
AIR COMPRESSOR - continued
5-7. CLEANING, INSPECTION AND REPAIR.
NO.
ITEM(S)
ACTION
ITEM I.D.
-- ----- - ---- - -- - -- - - - - - --- -- - -- -- - --- - - - -- - - - - - - - - - - - - - -- - - - - -
WARNING
1.
2.
D r y c l e a n i n g s o l v e n t P - D - 6 8 0 , u s e d t o c l e an
p a r t s , i s p o t e n t i a l l y d a n g e r o u s t o p e r s o n n el
a n d p r o p e r t y .
Avoid repeated and prolonged
s k i n c o n t a c t b y w e a r i n g r u b b e r o r s o l v e nt
impermeable gloves when handling the solvent or
m a t e r i a l w e t w i t h d r y c l e a n i n g s o l v e n t.
Wash
hands immediately after exposure with soap and
w a t e r a n d u s e a l a n o l i n b a s e d s k i n c r e a m to
p r e v e n t s k i n d r y i n g .
Do not use near open
flame or excessive heat.
Flash point of sol-
vent is 100°F (38°C).
Ensure that ventilation
is adequate to reduce solvent vapor concentra-
tions below acceptable threshold limit values.
Crankcase Cover
a .
Clean with solvent.
b.
Inspect for cracks
or other damage.
c.
Inspect guide bushing
for wear or other
damage.
d.
Replace if damaged.
23
31
Centrifugal Unloader
a.
Clean with solvent.
b.
Inspect for damage or
restriction of movement.
c.
If damage or restriction
is discovered, repair or
replace.
I f r e p a i r is
c h o s e n d i s a s s e m b l e :
a a .
Unbend locking wire
36
and remove.
bb .
Remove pins securing
37
weights.
Clean and
inspect.
cc .
Remove weights,
38 to 40
plunger and spring.
Inspect for damage
or wear.
dd .
Inspect unloader body
41
for damage or wear.
ee.
Replace worn or damaged
components.
5-8