TM 5-4310-372-14
AIR COMPRESSOR - continued
5-7. CLEANING, INSPECTION AND REPAIR - continued
NO.
ITEM(S)
ACTION
ITEM I.D.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
8.
Piston Rings
Inspect for damage.
56,57,
NOTE
It is highly recommended that
be replaced any time that they
the piston.
WARNING
62,63
the piston rings
are removed from
D r y c l e a n i n g s o l v e n t P - D - 6 8 0 , u s e d t o c l e an
p a r t s , i s p o t e n t i a l l y d a n g e r o u s t o p e r s o n n el
a n d p r o p e r t y .
Avoid repeated and prolonged
s k i n c o n t a c t b y w e a r i n g r u b b e r o r s o l v e nt
impermeable gloves when handling the solvent or
m a t e r i a l w e t w i t h d r y c l e a n i n g s o l v e n t .
Wash
hands immediately after exposure with soap and
water and use a lanolin based skin. cream to
p r e v e n t s k i n d r y i n g.
Do not use near open
flame or excessive heat.
Flash point of sol-
vent is 100°F (38°C).
E n s u r e t h a t v e n t i l a t i o n
is adequate to reduce. solvent vapor concentra-
tions below acceptable threshold limit values.
9.
Flywheel
a. Clean with solvent.
b .
Inspect for cracks,
chipping or other
structural damage.
Inspect bore for
scoring.
co
Replace if damaged..
10. Oil Retainer (Seal)
Inspect for damage.
NOTE
It is highly recommended that the oil seal be
r e p l a c e d a n y t i m e
that it has been removed
from its housing.
11.
Crankshaft Assembly
a. Clean with solvent.
b .
Inspect crankshaft
for cracks, wear,
scoring or other damage.
co
Inspect bearings for
wear or other damage.
5-12
72
76
79