TM 5-4310-373-14
This task covers:
The removal of the motor starter enclosure.
INITIAL SETUP
Equipment Condition:
Tools:
Compressor Unit OFF
Main Power OFF
Materials/Parts:
As required
Approximate Time Required (minutes):
Personnel Required:
20
1 Mechanic
REMARKS
ACTION
LOCATION/lTEM
WARNING
Be sure main power is discon-
nected before doing any work
on electrical systems. Voltages
present in this equipment can
cause injury or death.
Loosen two screws.
1. Cover screws (1)
Open.
2. Cover (2)
Remove.
3. Nuts, washers (3)
PuII out of enclosure far
4. Starter assembly and
enough to tag and remove
base plate (4)
Figure 4-17. Motor starter enclosure
wires.
NOTE
Wires at ON/OFF switch in
cover do not have to be dis-
connected.
Tag and disconnect all wires
5. Wires (5)
on starter assembly.
Figure 4-18. Motor starter, replace
4-16
